W Windows Mode - Intermec EasyCoder C4 Reference Manual

Chapter 7—Commands
W – Windows Mode
This command is used to enable/disable the Windows command
Description
mode (special applications only).
Syntax
Wp
1
Parameters p
1
When enabled, the printer will accept Windows mode escape
Remarks
sequences to print data. When disabled, escape sequences will be
ignored up to the next linefeed.
The Windows mode escape sequences are only used by the
Windows Printer Driver. When working with a main frame or
other non-Windows host, this mode can be disabled to prevent
erratic operation.
Examples
WY↵
WN↵
110 Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
Windows Mode enable/disable:
Y Enables Windows Mode.
N Disables Windows Mode (default).
:Enables Windows Mode
:Disables Windows Mode