Jf Enable Top Of Form Backup - Intermec EasyCoder C4 Reference Manual

Chapter 7—Commands
JF – Enable Top of Form Backup
This command enables automatic top of form backup of the
Description
media.
Syntax
JF
Top of form backup is used in connection with the
Remarks
which makes the printer feed out an extra amount of media after
printing the label, as to allow the media to be torn, peeled, or cut
off properly.
By default, top of form is enabled, that is the media is pulled
back before printing the fi rst label in next batch as to allow the
printing to start at the top of the label.
Top of form backup can be disabled by a
any
when the end of the label becomes aligned with the printhead's
dot line. In case of a cutter, the
by an
memory and can be enabled again using a JF command.
Activating the cutter using an
as issuing a JF command.
Example
JF↵
74 Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
j command will be ignored, and the printer will stop feeding
O command. However, the j command is kept stored in
JB command, that is,
JB command must be preceeded
OC command has the same effect
:Enables top of form backup
j command,