Z Print Direction - Intermec EasyCoder C4 Reference Manual

Z – Print Direction
This command is used to select the print orientation.
Description
Syntax
Zp
1
Parameters p
1
This command affects the complete print image, including text,
Remarks
bar codes, graphics, lines, and boxes, as well as the location of the
reference point (see
Note that printing a test label in the Test Mode, or by means of
a U
ZT).
ZT Command:
ZB Command:
Example
ZB↵
Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
Print orientation:
T Start printing from the top of image buff er (default).
B Start printing from the bottom of image buff er.
R command).
or UP command, will reset the print direction to default (=
EASYCODER C4
:Starts printing from the bottom of the image buffer.
Chapter 7—Commands
Feed Direction
Feed Direction
113