O Options Select - Intermec EasyCoder C4 Reference Manual

Chapter 7—Commands
O – Options Select
This command is used to enable or disable various sensors and
Description
the cutter.
Syntax
O[S[,N[,D[,Cnnn|Cb]]]]
Parameters S
N
D
Cnnn
Cb
Parameters can be entered in any order. Default: ON
S: Reverse Gap Sensing Enabled
Remarks
This parameter reverses the operation of the label gap sensor so
it interprets a blockage of light as a gap between labels or similar.
Before using the S parameter, make sure to load the EasyCoder
C4 printer with the appropriate type of media. By default, the
sensor will interpret blockage of light as a label or similar.
N: Label Taken Sensor Disable
When the label taken sensor is enabled, the communication to
the printer will be BUSY as long as the sensor detects a label
in the outfeed slot. (Does not work with a cutter—use ON to
disable the sensor.)
D: Ribbon End Sensor Disable
The ribbon end sensor (thermal transfer models only) detects
refl ections from the trailing silvery part of the transfer ribbon.
Direct Thermal Mode: If the ribbon end sensor is disabled
parameter, density settings (see
table that gives an optimized printout for direct thermal printing.
Thermal Transfer Mode: If the ribbon end sensor is enabled,
an error will occur if no refl ection is detected. The density
settings (see
optimized printout for thermal transfer printing.
C: Cutter Enabled
If option C is enabled, cutting will be performed after print.
Commands
remain stored in memory.
If option C is disabled, no cutting will be performed after print.
Commands
disabled but its value will remain stored in memory.
84 Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
Enable reverse gap sensing.
Disable label taken sensor.
Disable ribbon end sensor
Print nnn labels (1-255) before cutting.
Print batch before cutting.
D command) are interpreted via a table that gives an
JF and JB will be disabled, but their values will
JF and JB will be enabled. Command
D command) are interpreted via a
f will be