Memory; Direct Mode - Intermec EasyCoder C4 Reference Manual

In the Dump Mode, the output is the same label as produced by means
of a U command, but an extra line will be appended saying "now in
DUMP". Then the printer waits for ASCII dump printing.
Send a string of characters or a label form to the printer and tap the Feed
key to produce a printout. Dump mode will also print control characters,
see character set table on
To return to normal mode, briefl y tap the Feed key. A label with the
message "out of DUMP" will be printed.

Memory

The fi rmware has memory allocation for print image buffer, form,
graphic, and external font memory. The fi rst time the printer is used, it is
automatically initialized to default settings, see
The M memory command sets the image buffer, the form memory,
and graphic memory area. The remaining memory space, if any, is
allocated to the external font memory, which is intended for bitmap fonts
downloaded using external software.

Direct Mode

You can print a label without using a predefi ned format by sending write
commands (text, bar codes, graphics, lines and boxes) to the printer
after having cleared the image buffer using an
remains stored in the image buffer and can be printed over and over again
by sending new P
command, or by retrieving and printing a Form (see
The Direct Mode is also used for retrieving and printing preprogrammed
label formats, for the issuing of global setup commands, for deleting
forms and graphics from memory, and to make the printer produce a
number of different reports.
Intermec EasyCoder ESim v4.00—Programmer's Reference Manual
page 137.
print commands, until the buffer is cleared by an
Chapter 1—General Information
page 14.
N command. The label
FR command).
N
3