Servicing Selector Lever - Opel 1900 1973 Service Manual

(on Manta models, turn adjuster) until ball end of
cable rests firmly against lever.
2. At this point, measure length of exposed detent
inner cable. Depress accelerator pedal
again measure inner cable. If correctly adjusted, de-
tent cable should move approximately 3/S inch.
Servicing Selector Lever
1. Unscrew console from floor panel, on small con-
sole remove three (3) attaching screws and on large
console remove four (4) screws. The fourth screw is
accessible after removal of ash tray. See Figure 7C-
88.
Figure 7C-88
Figure 7C-89
AUTOMATIC TRANSMISSION 7C- 93
2. Unplug cigar lighter and lamps from console and
3.
From below vehicle, remove selector rod from
intermediate selector lever.
and
4. Remove neutral start switch (A) and remove sup-
port housing attaching bolts. See Figure 7C-89.
5. Remove support housing and, from the underside
of support housing, remove three (3) support attach-
ing bolts. See Figure 7C-90.
6. Remove intermediate selector lever (B) from shaft
and remove assembly from support housing. See Fig-
ure 7C-92.
Figure 7C-90
Figure 7C.92