b. Remove retaining screw in headlamp lever handle
and remove handle.
type studs, unsnap studs by prying cover up and
work cover upwards over shift lever and rubber shift
lever boot.
5. Remove left cover and right plug in instrument
panel cover and through openitigs remove instru-
ment panel attaching screws (points A and B). See
Figures 9A-7 and 9A-8. At this point it will be neces-
sary to lower the steering column, refer to Group 3
for this procedure.
Figure 9A-7 Instrument Panel Cover Screw Cover and
Plug
Locations
Figure SA-8 Location of Hidden Screws
6. Remove two multiple wire plug connectors from
steering column harness.
7. Detach speedo cable
8. Remove dir&ional signal flasher unit. See Figure
Figure 9A-9 Directional Flasher Unit
9. Remove 6 instrument cluster retaining screws. See
Figure 9A-10.
Figure SA-10 Removing Instrument Cluster detaining
10. Grasp instrument cluster and pull straight back,
being careful of wires, etc. See Figure 9A-11.
11. Unscrew heater controls (A) and support bracket
(B). See Figure 9A-12.
12. Disconnect heater and defroster duct hoses'from
instrument panel. See Figure 9A-13.