Opel 1900 1973 Service Manual page 489

1973 OPEL SERVICE MANUAL
2. Insert third clutch drum and input shaft through
top of second clutch drum seating third clutch drum
splines into the second clutch plate splines. See Fig-
ure x2- 212.
Figure 7C-2 12
3. Holding second and third clutch assemblies by the
input shaft, lower into transmission case, indexing
ring gear in second clutch drum with long planetary
pinion gear teeth. See Figure 7C-213.
Figure 7C-213
Installation of Reverse Clutch
A. Dry composition plates with compressed air and
inspect the composition surface for:
1. Pitting and flaking
2. Wear
3. Glazing
4. Cracking
5. Charring
6. Chips or metal particles imbedded in lining
If a composition drive plate exhibits any of the above
conditions, replacement is required.
B. Wipe steel plates dry and check for heat discolora-
tion. If the surface is smooth and an even color smear
is indicated, the plates should be reused. If severe
heat spot discoloration or surface scuffing is in-
dicated, the plates must be replaced.
2. Install the steel reaction plate into the case. See
Figure 7C-214.
Figure 7C-2 14
3. Install reverse clutch steel plate, composition
plate, steel plate, composition plate, etc., into case.
Use a liberal amount of transmission fluid.