Opel 1900 1973 Service Manual page 506

2. Remove headlamp assembly and remove multiple
plug from wire set.
3. Disconnect Bowden control wire(B). Loosen link-
age at the clamp screw (A) and disconnect linkage in
direction of arrows. See Figure SA-9.
Figure Disconnecting
4. Mark support plate at its circumference and
remove it. The marking facilitates the adjustment on
reinstallation. See Figure SA-2.
5. Mark swivel plate at its circumference and remove
it. See Figure 8A-3.
Figure Removing
Linkage
Headlamp Assembly
HOOD, FENDERS, AND GRILLE
6. To avoid damage cover headlamp upper and lower
edges with tape.
Turn headlamp 90 degrees and carefully remove
headlamp housing in direction of arrow. See Figure
7. Through access hole on fender underside, remove
the two attaching screws and the screw at the upper
deflector panel. See Figure 8A-11.
Figure EA.1 1 Locking Mechanism Attaching Screws
8. Prior to removing, mark the individual single
plugs (left headlamp only) and remove lock assem-
bly. See Figure 8A-12.
Figure EA.1 2 Headlamp and Headlamp Indicator
Switches