Opel 1900 1973 Service Manual page 386

4. With Special Tool J-2291 1 inserted, take counter-
shaft gear unit out of transmission case. Remove
both thrust washers.
Removing Selector Shaft
and remove reverie speed shifter intermediate lever.
See Figure 7B-24.
Figure 78-24 Driving Out Reverse Intermediate Lever
Pin
2. To remove all pins, use a l/8 inch pin punch. Turn
the selector shaft so that lock pins are in vertical
position. First, drive lock pins out of third and fourth
speed intermediate lever and then out of first and
second speed intermediate lever. See Figure 7B-25.
Figure 78-25 Removing Lock Pins from Selector Shaft
and Intermediate Levers
MANUAL TRANSMISSION
3. Push selector shaft out of case and remove inter-
mediate levers.
4. With screwdriver, pry out selector shaft oil seals
on transmission case.
Removing First and Second Gear Shifter Shaft,
Yoke, and Cam
1. Pull out both lock ball plugs using Tool J- 21715
with Slide Hammer J-7004-1. Remove thrust
springs.
2. With transmission in first gear, drive lock pins out
of shifter yokes and shifter shaft cam. See Figure
Figure 78-26 Position of Lock Pins for Shifter Forks
and Selector Dogs
3. Turn extension housing until shifter shaft is ex-
posed. From the rear of transmission, drive out first
and second speed shifter shaft. Use suitable brass
drift. See Figure 7B-27.
Figure 78.27 Removing Shifter Shafts