Figure 98.206 Evaporator Mounting Bracket Bolts
Passenger Side
8. Remove inlet and outlet pipes from evaporator
and tape closed the refrigerant lines and also the
open ends of the inlet and outlet pipes of the evapora-
tor. See Figure 9B-208.
Figure 98.208 Inlet and Outlet Pipes and O-Rings
9. Lift off the mounting bracket and remove the
evaporator assembly from the car.
10. Remove the resistor assembly. See Figure 9B-
2 0 3 .
SEAL
AIR CONDITIONER SYSTEM. GT
Figure 98.209 Evaporator and Blower Assembly
11. Remove blower case and blower motor attaching
and remove assembly.
Installation
Figure 98.210 Electrical Schematic