Opel 1900 1973 Service Manual page 616

1973 OPEL SERVICE MANUAL
11. Grasp instrument cluster and pull straight
being careful of wires, etc. See Figure 9C-7.
Figure Removing
12. Disconnect radio harness plug and antenna lead-
in cable from back of radio. See Figure 9C-8.
Figure 9C-8 Removing Radio Harness Plug
13. Remove radio knobs from radio.
14. While supporting radio, remove radio shaft re-
taining nuts. Remove radio. See Figure 9C-10.
Fasteners in Installation are important at-
taching parts in that they could affect the perform-
ance of vital components and systems, and/or could
result in major repair expense. They must be re-
placed with one of the same part number or with an
equivalent part, if replacement becomes necessary.
Do not use a replacement part of lesser quality or
substitute design. Torque values must be used as
specified during reassembly to assure proper reten;
back,
Instrument Cluster
Figure SC-10 Removing Radio
1. Install radio into instrument cluster and secure
with retaining nuts. See Figure 9C-10.
2. Plug radio harness and lead-in cable into radio.
See Figure 9C-8.
3. Install radio knobs and carefully push cluster back
into instrument panel housing, making sure electri-
cal wires, etc., are not pinched. See Figure 9C-7.
4. Install six (6) cluster retaining screws. See Figure
5. Support column assembly and install ground wire
and hex head bolts, torquing to 14 lb.ft.
6. Install NEW tear bolts and tighten until head of
bolt is twisted off.
7. Connect ignition and directional signal wire plugs.
8. Connect speedometer cable.
9. Install flasher unit and hex head screw. See Figure
10. Install hex head screw through opening on right
side and install trim plug. See Figure 9C-2.
11. Install trim cover on left side. See Figure 9C-3.
Shaft Retaining Nuts