Opel 1900 1973 Service Manual page 368

2. CLUTCH ASSEMBLY
3. ASSEMBLY MARKS
4. CLUTCH ALIGNING
ARBOR J-22934
Figure 7A-5 Clutch Installation
SPECIFICATIONS
GENERAL
SPECIFICATIONS
Clutch Specifications
Type . . . . . . . . . . . . . . . . . . . .
Pedal Lash _ 3/4" to l-1/4"
Driven Plate Facings ......................................................................................
Number of Facings ....................................................................................................................
Facing Attachment ........................................................................................................
Dampening ..................................................................................
Vibration
Bolt Tightening Specifications
Part
Bolt Flywheel to Crankshaft ........................................................
Clutch Cover to Flywheel ....................................................
Bolt Transmission to Clutch Housing ......................................
Bolt Starter to Clutch Housing ..................................................
Support to Clutch Housing ................................................
Nut
Intake and Exhaust Manifold to Cylindei Head ............
Bolt
CLUTCH CONTROL CABLE REMOVAL AND
INSTALLATION
(SEE FIGURE 7A.6 OR 7A-7)
If a new cable was installed or the cable adjustment
was changed during an operation, x-adjust cable
afterwards.
Removal
1. Disconnect return spring and cable with ball end
from release lever. Slide control cable out of eye in
clutch housing.
2. With a screwdriver, pry E-ring out of groove in
control cable, at tirewall, and disconnect cable from
clutch pedal.
3. Pull cable out of retainer on dash panel and
remove washers and rubber grommet.
Installation
1. Slide control cable ball end through eye in clutch
housing. Connect to lever and (on GT) install return
spring.
2. Replace washers and rubber grommet, slide
through retainer on dash panel, and connect to
clutch pedal. To adjust, refer back to Clutch Adjust-
ment paragraph c or d.
Location
Single Plate - Dry Disc
Woven Asbestos
2
Riveted
4 Torsional Springs
Torque
43
36
32.36
40
4
33
cable