Opel 1900 1973 Service Manual page 471

1973 OPEL SERVICE MANUAL
Figure 7C-151
Figure 7C-152
30. Install new oil seals on reverse clutch piston. See
Figure 7C-153.
31. Install reverse clutch piston onto rear face of oil
pump using liberal amount of transmission fluid. See
Figure 7C-154.
32. Inspect reverse clutch piston springs. Evidence of
extreme heat or burning in the area of the clutch may
have caused the springs to take a heat set and would
justify replacement of the springs.
33. Install the twenty-four reverse clutch piston re-
turn springs.
REVERSE CLUTCH
Figure 7C-153
Figure 7C-154
34. Install retaining seat.
35. Compress return springs using second and re-
verse clutch piston spring compressor tool J-2590-12
with adapter J-21420-1. Care should be taken not to
damage retainer should retainer catch in snap ring
groove. See Figure 7C-155.
36. Install snap ring using snap ring pliers such as J-
8059. See Figure 7C-155. Do not air check reverse
clutch as the clutch is not complete and damage to
the return spring retaining seat may occur.
H
SEAL