Opel 1900 1973 Service Manual page 543

1973 OPEL 3ERVlCE MANUAL
and circulated through the system via a 3/16 inch
diameter oil passage through the shaft center and
also four 5/64 inch diameter holes drilled perpen-
dicular to the shaft. The inner rotor is driven by the
shaft.
TUBE
Figure 98-27 Compressor Oil Flow
4. Shaft and Gash Plate Assembly - The shaft and
an elliptical plate positioned obliquely to the shaft.
As the plate and shaft rotate, the surface of the plate
moves to and fro lengthwise relative to the centerline
of the shaft. This reciprocating motion is transmitted
to the pistons which contact the surface of the wash
plate. A woodruff key locks the wash plate onto the
Figure 98.26 Compressor Front and Rear Heads
shaft. The wash plate and shaft are serviced as an
assembly. The shaft is driven by a pulley when the
magnetic clutch is energized. A needle thrust bearing
and L mainshaft bearing support the shaft horizon-
tally and vertically.
5. Needle Thrust Bearing and Races - Two needle
thrust bearings, each "sandwiched" between two
races are located on either side of the wash plate
hub. The front needle thrust bearing and races pro-
vide 0.010" to 0.015" clearance between the top of
the pistons and the rear side of the front suction valve
reed disc (see Figure 9B-28). The rear needle thrust
bearings and races provide 0.0005" to 0.0015" clear-
ance between the hub of the wash plate and the rear
hub of the rear cylinder. Races of various thicknesses
are provided for service replacement to achieve re-
quired clearances when rebuilding units.
6. Cylinder Assembly and service Pistons (Factory
installed pistons are ringless) -The cylinder assembly
(front cylinder and rear cylinder) is serviced only
a matched set. Alignment of the two halves is main-
tained by two dowel (locater) pins.
The double ended pistons are made of cast alumi-
num. There are two grooves on each end of the ser-
vice piston. The outer grooves will receive a piston
ring. The inner grooves act as oil scraper grooves to
collect any excess oil. Two oil return holes are drilled