Opel 1900 1973 Service Manual page 381

1973 OPEL SERVICE MANUAL
GEARSHIF
INTERMEDIATE
SHIFT FINGER1
SELECTOR LEVER
Figure 78-B
3. Unhook tension spring of gearshift lever and, after
removal of retaining washer, push pivot pin out of
intermediate shift lever. See Figure 7B-10.
1. Prior to installation, grease support and spherical
end of shift finger with protective grease.
2. Replace lever, pivot pin, retaining washer, and
tension spring. Reposition protective cap and bel-
lows and button cap from below. Replace console.
3. In Figuie 7B-11, distance A - 8.07".
SHAFT, .
JT "B'
Figure 7B-10
Figure 78.1 1
4. After installation, check as to whether pull ring
can be lifted up approximately .04 to .08", whereby
the stop sleeve must still rest against intermediate
shift lever. Otherwise, loosen threaded pin for
Adjust distance B - free travel - by lifting up pull
ring, and retighten threaded pin. See Figure 7B- 13.
REPLACING BOWDEN CONTROL WIRE IN
GEARSHIFT LEVER