Specifications - Opel 1900 1973 Service Manual

1973 OPEL SERVICE MANUAL
Figure 6F-5 Replacing Vacuum Motor Assembly
2. Lift vacuum motor, cocking it to one side to un-
hook motor linkage at the control door.
3. Install in reverse sequence.
ure 6F-6.
2. Pull vacuum hoses from sensor.
3. Note carefully the installed position of the sensor

SPECIFICATIONS

EMISSION CONTROL
Carburetor Inlet Air Regulated Temperature ..........................................................
Idle Mixture Setting (Lean From Best Idle)
Engine Thermostat Operating Temperature ......................................................................
SYSTEM SPECIFICATIONS
Figure 6F-6 Replacing Sensor Assembly
so that you can install new sensor in same position.
Then remove sensor.
4. Install sensor and gasket assembly in air cleaner
in same position as noted in Step 3. This is to elemi-
element. See Figure 6F-4.
5. Install sensor retaining clip. Meanwhile support-
ing sensor around the outside rim to prevent damage
to the temperature sensing spring.
6. Reinstall hoses.
vacuum
..............................................................
115" k 20
220
189