Opel 1900 1973 Service Manual page 152

Installation of Sun Roof Frame
1. Slide sun roof frame into lower slot of guide rails,
position fully rearward and reattach guide rails to
roof.
NOTE: Be sure guide rail retainers at rear of guide
rails are positioned with their dowels in bores of roof
frame.
2. Install upper corner plates and secure in place..
3. Install sun
roof panel.
REMOVAL AND INSTALLATION OF VELVET STRIP
ON SUN ROOF OPENING, AND VELVET STRIP AND
WEATHERSTRIP ON REAR OF SUN ROOF PANEL
Removal of Velvet Strip on Sun Roof Opening
1. Fully open sun roof.
2. Carefully pull off velvet strip using solvent to dis-
solve cement. Clean area thoroughly before installing
new velvet strip.
Installation of Velvet Strip On Sun Roof Opening
1. Cut away for a distance of 1.5 inch the velvet
material on velvet strip that will be on the outside
when strip is cemented in positio
this dimension the plastic cord i
not cut away velvet material on 1
strip which is to be cemented
2. Using nitrile vinyl trim adhesive (3M Vinyl Trim
Adhesive, Permalastic Viny1 Trim Adhesive or
equivalent) apply sparingly to both sun roof opening
and side of velvet strip to be cemented.
3. Immediately install new velvet strip and position
so that upper edge of velvet strip is flush with car
roof.
4.
Clean off excess cement
tact velvet strip.
Removal of Velvet Strip and Wea'therstrip
of Sun Roof Panel
1. Remove sun roof panel.
2. Carefully detach weatherstrip and velvet strip
from sun roof panel using solvent as required to
new velvet strip and weatherstrip.
stalling
Also cut off to
being careful not to con-
on Rear
ROOF AND SUN ROOF
Installing Velvet Strip and Weatherstrip On Rear
of Sun Roof Panel
1. Using nitrile vinyl trim adhesive (3M Vinyl Trim
Adhesive Permalastic Viny1 Trim Adhesive or
equivalent) apply sparingly to vertical and horizontal
contact areas at rear of sun roof panel (see Figure 2F-
9) and also to side of velvet strip which will touch sun
roof panel.
REAR OF SUN ROOF PANEL
VELVET STRIP
I
APPLY CEMENT TO HORIZONTAL AND
VERTICAL SURFACES,TO BOTH SIDES
OF VELVET STRIP AND TO SIDE AND
BOTTOM OF WEATHERSTRIP
Figure ZF-9 Installing Velvet Strip and Weatherstrip
on Rear of Sun Roof Panel
2. Immediately install new velvet strip and position
so that top edge of velvet strip is flush with sun roof
panel.
3. Apply cement to outboard edge of velvet strip and
to top and bottom contact surfaces
and install weatherstrip in position.
4.
Clean off excess cement being careful not to con-
tact velvet strip.
5. Install sun roof panel.
REMOVAL AND INSTALLATION OF REAR GUIDES
AND CABLE
Removal of Rear Guides and Cable
2. Crank rear lifter guides fully rearward and then
remove crank handle and cable crank.
CAR ROOF
of weatherstrip,