Opel 1900 1973 Service Manual page 608

1973 OPEL SERVICE MANUAL
2. Remove the retaining screws from the duct as-
sembly. See Figure 9B-190.
3. Lift up duct assembly and note the position of the
air sensing capillary so that it can be reinstalled in
the same location as when removed.
4. Remove the temperature control switch retaining
screws and remove switch.
Installation
1. Install the temperature control switch and secure
with the retainer screws.
2. Position the air sensing capillary in the exact
location as was noted when removing.
3. Install the duct assembly retaining screws.
4. Install the negative battery cable.
REMOVAL AND INSTALLATION OF RESISTOR
ASSEMBLY
R e m o v a l
1. Remove the negative battery cable from the bat-
tery.
2. Remove the luggage tray attaching screws and
lift out tray. See Figure 9B-194.
Figure 98-194 Luggage Tray
3. Remove all evaporator cover attaching screws
and remove cover. See Figure 9B'-195.
Figure 98.195 Evaporator Cover Assembly and
Attaching Screws
4. Remove the electrical plug
resistor assembly.
5. Remove 2 resistor attaching screws and remove
resistor assembly. See Figure 9B-197.
Figure 9B-196 Resistor and Blower Motor
Connections
from the
connector