Remote Control - Rinnai Timberflame IB35 ETR Operating And Installation Instructions

OVERRIDE
•
This function is intended to be used to manually override the current operation of the heater. For
example; If the heater is in standby mode (ie. between finishing time and starting time of a Timer),
and the OVERRIDE button is selected, then the heater will begin to operate and heat the room.
To operate the OVERRIDE simply press the OVERRIDE button. The OVERRIDE indicator will flash.
To manually deactivate the OVERRIDE simply press the OVERRIDE button again. The OVERRIDE indicator
will go out, and the heater will return to standby mode.
The heater will continue to operate on OVERRIDE until the OVERRIDE button is pressed again, or
one of the Timers takes over the operation of the appliance. This means that the OVERRIDE mode
will automatically drop out if a programmed starting time is reached. The appliance will then return to
operating at times programmed into the Timer(s).

REMOTE CONTROL

•
Remote Control will not turn heater ON if Timer(s) have been selected.
To manually operate when Timer(s) are not selected, simply press the ON or OFF button.
To alter the temperature at anytime while the heater is operating, simply press the " " or " " buttons.
ON BUTTON
Operates the heater
manually.
OFF BUTTON
Stops heater
manually.
TEMPERATURE
ADJUSTMENT
Increases or decreases
the temperature setting.
Some fluorescent lights may interfere with the transmission of remote control signals, in this case changing
the position from which you are operating the remote control may help.
Avoid getting the remote control wet, or dropping it.
The remote control works within 5 metres and an angle of 40
Only use the battery type specified. (CR2032).
Remove battery if control is not going to be used for a long period. This will help avoid damage from
leaking batteries.
If the Timer(s) have been selected, and the heater is in standby mode, and the OFF button on the
Remote Control is pressed, the Timer(s) will be deactivated.
°
to the receiver on the heater.
5
TO REPLACE
BATTERY
Simply open the back of
the remote control and
replace Lithium battery.
TYPE: CR 2032
BATTERY
Power source
for operating
remote control