Remote Control - Rinnai Royale FS35 ETR Operation & Installation Manual

CUSTOMER INFORMATION - OPERATION

Remote Control

The Remote Control will not turn the heater ON if Timer(s) have been selected.
To manually operate when Timer(s) are not selected, simply press the ON or OFF button.
To alter the temperature at anytime while the heater is operating, simply press the
ON BUTTON
Operates the heater
manually.
OFF BUTTON
Stops heater
manually.
TEMPERATURE
ADJUSTMENT
Increases or decreases
the temperature setting.
Some fluorescent lights may interfere with the transmission of remote control signals, in this case
changing the position from which you are operating the remote control may help.
Avoid getting the remote control wet, or dropping it.
The remote control works within 5 metres and at an angle of 40° to the receiver which is located on the
lower front edge of the heater.
Only use the battery type specified (CR2032).
Remove the battery if control is not going to be used for a long period. This will help avoid damage from
leaking batteries.
If the Timer(s) have been selected, and the heater is in standby mode, and the OFF button on
the Remote Control is pressed, the Timer(s) will be deactivated.
Royale - Freestanding - ETR - 3 -
or button.
TO REPLACE
BATTERY
Simply open the back of
the remote control and
replace Lithium battery.
TYPE: CR 2032
BATTERY
Power source
for operating
remote control
Issue 3 - ©Rinnai