Connect To The System Console - Sun Oracle SPARC T5120 Installation Manual

{8} ok
2. Type the console escape sequence (by default #. (Hash-Period)) to return to the
ILOM prompt.
3. Check the POST execution result with the following command:
-> show /SP/faultmgmt -level all
Note – Depending on the configuration of ILOM, POST variables, and whether
POST detected faults or not, the server might boot, or the system might remain at the
ok prompt. If the system is at the ok prompt, type boot.
4. Use the set /SYS keyswitch_state=normal command to return the virtual
keyswitch to Normal mode (default) so that the system can power on and start
the boot process.
-> set /SYS keyswitch_state=normal
Related Information
"Connect to the System Console" on page 60
■

▼ Connect to the System Console

Output from POST, OpenBoot, and the Solaris OS is displayed in the system console
using the network console on the service processor.
●
Type the start /SP/console command.
Multiple users can be connected to the console, but only one can be attached.
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started.
Note – For more information about POST output, refer to the SPARC Enterprise
T5120 and T5220 Servers Service Manual.
60 SPARC Enterprise T5120 and T5220 Servers Installation Guide • October 2010
To stop, type #.