Connecting The Dc Input Power Cords To The Server - Sun Oracle SPARC T5120 Installation Manual
Hide thumbs
Also See for SPARC T5120:
- Administration manual (70 pages) ,
- Getting started manual (6 pages)
Table of Contents
Advertisement
FIGURE:
Related Information
"Connecting the DC Input Power Cords to the Server" on page 98
■
▼ Connecting the DC Input Power Cords
to the Server
1. Ensure that the circuit breaker to your power source is turned off.
Caution – Do not proceed with these instructions until you have turned off the
power from the DC power source through the circuit breakers.
2. Route the power cables in the rack and secure the cables with nylon tie wraps.
3. Connect the chassis ground wire to the facility earth ground and ensure that
this connection has proper bonding.
98
SPARC Enterprise T5120 and T5220 Servers Installation Guide • October 2010
Assembling the Strain Relief Housing
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARC T5120 and is the answer not in the manual?