Log Into The Service Processor Using The Network Management Port; Using The Service Processor For Common Operations - Sun Oracle SPARC T5120 Installation Manual

Hide thumbs Also See for SPARC T5120:
Table of Contents

Advertisement

▼ Log Into the Service Processor Using the
Network Management Port
Note – You must configure the service processor parameters shown in
the Service Processor Network Management Port" on page 55
network management port.
Open an SSH session and connect to the service processor by specifying its
network address.
% ssh root@xx.xxx.xx.x
...
Are you sure you want to continue connecting (yes/no)? yes
...
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Sun(TM) Integrated Lights Out Manager
Version 2.0.0.0
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
->
Related Information
"Perform a Normal System Initialization" on page 61
Using the Service Processor for Common
Operations
The following topics are described in this section:
"Power On the System" on page 59
"Connect to the System Console" on page 60
"Perform a Normal System Initialization" on page 61
58
SPARC Enterprise T5120 and T5220 Servers Installation Guide • October 2010
"Configure
before you can use the

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPARC T5120 and is the answer not in the manual?

This manual is also suitable for:

T5220

Table of Contents