Sun Oracle SPARC T5120 Installation Manual page 66

■
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
■
a. Set the service processor to accept a Static IP Address.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
b. Set the IP address for the service processor.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
c. Set the IP address for the service processor gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
d. Set the netmask for the service processor.
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
2. Use the show /SP/network command to verify that the parameters were set
correctly.
The code example shows parameters that have been set to convert a service
processor from a DHCP configuration to a static configuration.
-> show /SP/network
/SP/network
56 SPARC Enterprise T5120 and T5220 Servers Installation Guide • October 2010
dhcp - Set up the network connection with a dynamically created IP
configuration. If you choose to use a dynamically created IP address (use
DHCP to retrieve the network setting), set pendingipdiscovery to dhcp.
static - Set up the network connection with a static IP configuration. If you
choose to configure a static IP configuration. set the parameters
pendingipdiscovery, pendingipaddress, pendingipgateway, and
pendingipnetmask as follows.
This example uses 255.255.255.0 to set the netmask. Your network
environment subnet might require a different netmask. Use a netmask number
most appropriate to your environment.
Targets:
Properties:
commitpending = (Cannot show property)