Tait TM8100 mobiles Service Manual page 83

Audio Signal
for Speaker
Summing Circuit
Buffer Amplifier
Audio Power
Amplifier
Control of Audio
Power Amplifier
Microphone Signals
Auxiliary Audio
Input
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
The audio signal for the speaker is generated by IC204 (
This signal is post-volume-control and has a pre-emphasized frequency
response. The signal is then processed by R218, R217 and C231 (C205) to
restore a flat frequency response and reduce the signal level to that required
by the audio power amplifier.
The top of C231 (C205) is where side tones are summed in and the
signal is obtained. C201 and R211 pre-emphasize and attenuate the
AUD
side-tone signal to give a flat side-tone frequency response and reduce the
input to an appropriate level.
IC201 (pins 8 to 10) amplifies the signal at the top of C231 (C205) by 19dB
and drives the
CDC RX AUD
The capacitor C212 provides AC output coupling and R225 ensures
stability. The DC bias for this amplifier is derived from IC204.
The signal at the top of C231 (C205) is fed via C204 to the audio power
amplifier IC202. IC202 has 46dB of gain and a differential output
configuration. C209, C211, R252 and R253 ensure stability of the amplifier
at high frequencies. When operational, the output bias voltage for IC202 is
approximately half the radio supply voltage. When not operational, the
output becomes high impedance.
Power up, power down, and muting of IC202 is controlled by two signals
from the digital section,
consisting of Q200, Q201, R200 to R206, R210 and R250 converts the
two digital signals to the single three-level analog signal required by IC202.
There are two microphone source signals:
from auxiliary or internal options connector
■
ITF AUX MIC AUD
from control head.
■
ITF CH MIC AUD
The biasing for electret microphones is provided by a filtered 3.0V supply
via R226 and R227. The components R209 and C202 provide the supply
filtering. The microphone inputs to IC204 (
balls) are differential. The negative inputs are decoupled to the
VINNORN
filtered 3.0V supply by C215 and C216. The positive inputs are biased to
approximately 1.5 V by R229, R232, R230 and R233. AC coupling and
DC input protection is provided by C213 and C214.
The auxiliary audio input signal
input of IC205. R241 combined with internal clamping diodes in IC205
provide DC protection for the ADC input. IC205 provides the input biasing
of approximately 1.5V.
system interface line via C212 and R225.
1 and
DIG AUD PA EN DIG AUD PA EN
VINAUXP
is DC-coupled to the ADC
ITF AUD TAP IN
ball).
VOUTAUXP
CDC RX
2. The network
, and
, ,
VINAUXN VINNORP
Circuit Descriptions 83