Tait TM8100 mobiles Service Manual page 128

Table 4.6 CCTM commands in the transmitter category (part 2)
Command
Transmitter category
331 – Final bias 1
Sets or reads the bias voltage for
the first PA
332 – Final bias 2
Sets or reads the bias voltage for
the second PA
128 General Information
Entry at keyboard
331 (to read value)
331 x (to set value)
where x is the DAC value of the
required bias voltage
(any integer from 0 to 255)
332 (to read value)
332 x (to set value)
where x is the DAC value of the
required bias voltage
(any integer from 0 to 255)
Usage
Response on screen
x
where x is the DAC value of the
bias voltage (an integer from 0 to
255)
None
x
where x is the DAC value of the
bias voltage (an integer from 0 to
255)
None
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007