Tait TM8100 mobiles Service Manual page 165

Task 3 —
Final Inspection
Task 4 —
Final Test
Task 5 —
Final
Administration
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
8. On receiving the licence file, run the programming application on the
test PC. On the menu bar click Tools > Optional Features.
The Software Feature Enabler dialog appears.
9. Use the licence file to enable the appropriate software features.
The procedure is given in the on-line help facility under the heading
Enabling a feature. Go to
Make a final inspection of the exterior to check that no mechanical parts
have been damaged during the repair. Repeat the inspection given in
"Visual Inspection" on page
Test the radio to confirm that it is fully functional again. The recommended
tests are listed in Table 6.2
used for many of these tests.) It is good practice to record the test results on
a separate test sheet. A copy of the test sheet can be supplied to the Customer
as confirmation of the repair.
The final administration tasks are the standard workshop procedures for
updating the fault database and returning the repaired radio to the Customer
with confirmation of the repair.
If the radio could not be repaired for one of the following reasons:
fault not located
■
repair of fault failed
■
required repair is level-3 repair.
■
Level-1 service centres should return the faulty radio to the nearest ASC,
and level-2 service centres should return the radio to the ISC. Supply details
of the Customer, the fault and, if applicable, the attempted repair.
Task 3.
155. Rectify any damage.
to Table 6.4. (The calibration application can be
Servicing Procedures 165