Tait TM8100 mobiles Service Manual page 530

25.1.1 Overview
25.1.2 Parts Required
Figure 25.1 Parts for remote control-head installation
i
d
b torso interface
c control-head interface
d
remote U-bracket
e remote cable
f self-drilling screw
g thumb screw
530 Installing a Remote Kit
Installing the control head remotely is done in six steps:
1. Remove the control head from the radio body, if necessary.
2. Install the torso interface
3. Mount the remote U-bracket
4. Install the control-head interface
the remote control-head assembly in the remote U-bracket.
5. Mount the U-bracket in the required position and install the radio
body in the U-bracket.
6. Route the remote cable
assembly and the radio body.
The following diagram identifies the parts for remote control-
head installation and shows how they fit together.
e
f
b
onto the radio body.
d
in the required position.
c
onto the control head and install
e
between the remote control-head
1)
1@
c
g
h RJ45 bung
i control-head interface loom
j
torso-interface loom
1) earthing tag
1! earthing-tag screw
1@ remote cable grommets
© Tait Electronics Limited November 2007
1!
j
h
b
TM8100/TM8200 Service Manual