Tait TM8100 mobiles Service Manual page 594

33.1.2 Handset Installation
33.1.3 Connecting the Handset to the Radio
594 TMAA10-02 Handset
Table 33.1 Handset PCB connector wiring
b
c
d e
1. Press the pushbutton and remove the handset from the locking cradle.
2. Disassemble the locking cradle by removing the four locking cradle
screws.
3. Screw the handset mounting plate to the required mounting surface.
Note that mounting screws are not provided in this kit.
4. Clamp the top part of the locking cradle onto the mounting plate,
and secure it with the four locking cradle screws.
Important
The handset microphone grommet must be installed when-
ever the handset to radio cord is plugged into the microphone
socket. When installed, the grommet has two functions:
to prevent damage to the microphone socket when there
■
is movement of the microphone cord, and
to ensure that the control head is sealed against water,
■
dust and other environmental hazards.
1. Plug the radio to microphone cord into the microphone socket on
the radio control head.
2. Slide the grommet along the cord and push two adjacent corners of the
grommet into the microphone socket cavity.
3. Squeeze the grommet and push the remaining corners into position.
4. Check that the grommet is seated correctly in the cavity.
Handset PCB
Connector
10
f g h
© Tait Electronics Limited November 2007
Colour Reference
2 white d
or violet
3 blue e
8 brown f
9 yellow g
green h
TM8100/TM8200 Service Manual