Tait TM8100 mobiles Service Manual page 146

Closing the
Radio Body
146 Disassembly and Reassembly
5. While pressing down firmly on the diagonal edge of the
(refer to Figure
I
screws to 22lb·in (2.5N
is seated correctly on the bosses for the five internal screws
Figure 5.7 PAD TOP can on the top side of the main board
PAD TOP can
6. Clean off any excess thermal paste on the heat-transfer block.
7. Screw in the five screws
possible. Use a Torx T10 torque-driver to tighten the screws to
17lbf in (1.9N m).
· ·
8. Fit the RF connector seal
around its entire periphery.
9. If an auxiliary connector bung
The circled number in this section refer to the items in
page 139.
1. If an internal options board is fitted inside the lid, connect the loom
to the internal options connector.
2. Inspect the main seal in the lid for damage, and replace if necessary.
3. Place the lid assembly
4. Use a Torx T20 torque-driver to tighten the four screws
(2.5N m).
·
5. Slide the cover
the cover over the screw bosses.
6. Inspect the control-head seal for damage, and replace if necessary.
5.7), use a Torx T20 torque-driver to tighten the two
m). This will ensure that the main board
·
E
through the main board by hand as far as
j
. Ensure that the seal is properly seated
h
was fitted, fit the bung.
D
on the chassis
b
over the radio body and snap holes in the side of
© Tait Electronics Limited November 2007
PAD TOP
E
Figure 5.3 on
G
.
c
to 22lbf
TM8100/TM8200 Service Manual
can
.
in
·