Tait TM8100 mobiles Service Manual page 598

Power Connector
Wiring
Connecting the
Remote Speaker
598 TMAA10-03 and TMAA10-06 High-Power Remote Speakers
4. Run the free end of the speaker cable to the radio power cable and
install the two receptacles in the power connector, as described in the
"Power Connector Wiring"
Insert the flying lead receptacles into the power connector socket, as shown
in the diagrams below.
Note
The positive remote speaker wire has a white stripe.
1. TMAA10-03 remote speaker (25W radios)
For the TMAA10-03 remote speaker (25W radios), insert the flying
lead receptacles:
the positive wire and receptacle into the position nearest to the red
■
wire, and
the negative wire and receptacle into the position nearest to the
■
black wire.
+13.8V
(red)
flying lead
connector
ground
(black)
2. TMAA10-06 remote speaker (40W/50W radios)
For the TMAA10-06 remote speaker (40W/50W radios), insert the
flying lead receptacles:
the positive wire and receptacle into position 3, and
■
the negative wire and receptacle into position 2.
■
+13.8V
(red)
flying lead
connector
ground
(black)
speaker + (to pin 3)
To connect the remote speaker, plug the flying lead into the housing socket.
To disconnect the speaker, release the locking mechanism and unplug the
flying lead.
procedure.
speaker +
speaker –
speaker – (to pin 2)
c
d
power connector
© Tait Electronics Limited November 2007
power
connector
SPKR –
e
+
b
power connector
SPKR + rear view
TM8100/TM8200 Service Manual