Tait TM8100 mobiles Service Manual page 537

25.3.2 Disassembling the Control-Head Interface
Figure 25.5 Parts of the control-head interface
B
x5
C
D
TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
Disassemble only as much as necessary to replace the defective parts or to
swap the Micromatch connector loom. Re-assembly is carried out in reverse
order of disassembly.
1. Remove the remote cable from the RJ45 connector.
2. Unscrew the seven PT type screws
3. Remove the control-head interface loom (not illustrated).
B
and remove the PCB
Description
B
3 x 8 PT screw (x5)
C
control-head interface PCB
D
control-head interface
control-head interface loom 219-02914-00
a
Contact Technical Support for the exact IPN.
Installing a Remote Kit
C
.
IPN
a
346-10030-XX
a
316-06842-XX
537