Tait TM8100 mobiles Service Manual page 142

Removing an
Options Board
(Optional)
142 Disassembly and Reassembly
The radio may be fitted with an options board in the lid assembly, which
may or may not have an external options connector fitted in a provision in
the lid assembly.
The circled numbers in this section refer to the items in
1. If an external options connector is fitted:
Undo the two screws
■
(if fitted).
Undo the two D-range screwlock fasteners
■
2. Undo up to nine screws
E
lid assembly .
3. If an external options connector is fitted, a foam seal for the D-range
f
connector is fitted to the inside of the lid. Remove the foam seal
only if it is damaged.
Reassembly is carried out in reverse order of the disassembly.
Figure 5.5 Removing an options board
d
b
c
e
f
g
h
Torx T10
17lb·in (1.9N·m)
B screw 4-40x3/15 (x2)
C protective rubber cap
D
D-range screwlock fastener 4-40 (x2)
E lid assembly
b
and remove the protective rubber cap
h
and remove the options board
3/16 inch (5mm)
8lb·in (0.9N·m)
F foam seal for D-range connector
G options board (example)
H
screw M3x10, self-tapping (x9)
© Tait Electronics Limited November 2007
Figure 5.5.
d
.
G
from the
3614z_01
TM8100/TM8200 Service Manual
c