Tait TM8100 mobiles Service Manual page 500

Figure 19.2 Options extender board installation
c
1!
d
g
b radio lid
c external options connector bung
d foam seal
e external options connector cavity
f options extender board
g external options connector
500 TMAA01-05 and TMAA01-07 Options Extender Boards
7. Screw the options extender board to the mounting posts on the radio
lid using four M3x8 self-tapping screws
Tighten the M3x8 screws to a torque of 1.9N·m (17lbf·in)
Important
For the options extender board to be installed correctly in
the radio's options cavity, the internal options connector
loom
8. Plug the unattached end of internal options connector loom
the internal options connector on the radio main PCB.
9. Refit the radio lid and top cover to the radio and screw the external
options cover seal
two 4-40x3/16 screws
1@
h
1)
1)
must be looped in the way shown in
1!
over the external options connector, using the
1@
.
e
h screw-lock fasteners
i mounting posts
j M3x8 self-tapping screws
1) internal options loom
1! external options cover seal
1@ 4-40x3/16 screws
© Tait Electronics Limited November 2007
j
.
Figure
1)
b
i
f
j
TM8100/TM8200 Service Manual
19.2.
into