Wall Mounting The Base Station; Table 2-27 Base Station Leds States And Meanings - NEC SL1100 Hardware Manual

SL1100
3. Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly lights orange and then
turns off while it initializes and connects to the network. After the base station successfully initial-
izes and connects to the network, the LED lights green and remains steady on.
Table 2-27 Base Station LEDs States and Meanings on this page
LEDs and their meanings.

Table 2-27 Base Station LEDs States and Meanings

Color State
Green Flickering
Green Steady on
N/A Off
Orange Briefly on
Orange Flickering
Red Blinking
Red Blinking
Red Flickering
Red Steady on

6.3.2 Wall Mounting the Base Station

Follow the steps below to mount the base station to a wall.
Be sure the wall material can hold the weight of the base.
1. Hold the base in its final location and mark the screw location based on the measurements shown
in Figure 2-146 Base Mounting Dimensions on the next
2-90
Figure 2-145 Connecting the Base Station
Stage in base flash memory rewrite at the end of the base firmware update.
All operations normal.
No power in unit
OR
initializing and connecting to the network.
Powering on.
Stage in base flash memory rewrite at the end of the base firmware update.
Factory reset warning. A factory reset has been initiated or is in progress.
No Ethernet connection available
OR
handset registration failed.
Stage in base flash memory rewrite at the end of the base firmware update.
Critical error. Contact technical support.
provides a list of base station
Meaning
page.
ISSUE 1.0
Installation