Connecting The Base Station; Figure 2-144 Base Station Front And Back View; Figure 2-145 Connecting The Base Station - NEC SL1100 Hardware Manual

ISSUE 1.0

6.3.1 Connecting the Base Station

Figure 2-144 Base Station Front and Back View on this page
base station.
Front View
If your network connection does not provide Power Over Ethernet, you will need to order a base station AC
adapter and a standard Ethernet-to-PoE adapter. Contact Customer Service.
Follow the steps below to connect the base station.
1. Connect a standard Ethernet cable (Cat 5 or higher) to the Ethernet/PoE jack on the rear of the
base station.
2. Route the cable through the channel as shown in
the next page.
Hardware Manual

Figure 2-144 Base Station Front and Back View

provides a front and rear view of the
Rear View
Figure 2-145 Connecting the Base Station on
SL1100
2-89