Wall Mounting The Base Station; Table 2-30 Base Station Leds States And Meanings; Figure 2-163 Connecting The Base Station - NEC SL1100 Hardware Manual

ISSUE 5.0
2. Route the cable through the channel as shown in
page 2-115.
3. Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly lights orange and then
turns off while it initializes and connects to the network. After the base station successfully
initializes and connects to the network, the LED lights green and remains steady on.
Table 2-30 Base Station LEDs States and Meanings on page 2-115
LEDs and their meanings.
Color State
Green Flickering
Green Steady on
N/A Off
Orange Briefly on
Orange Flickering
Red Blinking
Red Blinking
Red Flickering
Red Steady on

6.4.2 Wall Mounting the Base Station

Follow the steps below to mount the base station to a wall.
Hardware Manual

Figure 2-163 Connecting the Base Station

Table 2-30 Base Station LEDs States and Meanings

Stage in base flash memory rewrite at the end of the base firmware update.
All operations normal.
No power in unit
OR
initializing and connecting to the network.
Powering on.
Stage in base flash memory rewrite at the end of the base firmware update.
Factory reset warning. A factory reset has been initiated or is in progress.
No Ethernet connection available
OR
handset registration failed.
Stage in base flash memory rewrite at the end of the base firmware update.
Critical error. Contact technical support.
Figure 2-163 Connecting the Base Station on
provides a list of base station
Meaning
SL1100
2-115