Mounting The Base Directly To The Wall; Figure 2-123 Placing The Base Unit On The Posts Of The Wall Plate; Figure 2-124 Plugging The Ac Adapter Into The Ac Wall Outlet - NEC SL1100 Hardware Manual

SL1100

Figure 2-123 Placing the Base Unit on the Posts of the Wall Plate

Because of variation in wall plates, this method is not recommended.
7. Plug the AC adapter into a standard 120 Vac wall outlet.
Do not use an outlet controlled by a wall switch.

Figure 2-124 Plugging the AC Adapter into the AC Wall Outlet

6.1.6 Mounting the Base Directly to the Wall

If a standard wall plate is not available, mount the telephone directly on the wall. Before mounting the
telephone, consider the following:
• Select a location away from electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
• Make sure the wall material can support the weight of the base unit.
• Use #10 screws with anchoring devices suitable for the wall material where the base unit will be
placed.
To mount the telephone:
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an inch between the wall
and screw heads for mounting the telephone.
2-76
ISSUE 1.0
Installation