Wall Mounting The Charging Unit; Figure 2-128 Inserting Screws For Wall Mounting; Figure 2-129 Wrapping The Ac Adapter Cord Around The Strain Relief - NEC SL1100 Hardware Manual

SL1100
6. Plug the other end of the short telephone cord into a telephone wall jack.
7. Plug the AC adapter into a standard 120 Vac wall outlet. Refer to
Adapter into the AC Wall Outlet on page
Do not use an outlet controlled by a wall switch.

6.1.7 Wall Mounting the Charging Unit

The charging unit can be wall mounted as well. Before mounting the charging unit, consider the
following:
• Select a location away from electrical cables, pipes, or other items behind the mounting location that
could cause a hazard when inserting screws into the wall.
• Make sure the wall material can support the weight of the charging unit.
• Use #10 screws with anchoring devices suitable for the wall material where the charging unit will be
placed.
To mount the charging unit:
1. Insert two mounting screws as shown below. Allow about 3/16 of an inch between the wall and
screw heads for mounting the telephone.
2. Plug the AC adapter in the charging unit. Wrap the AC adapter cord around the strain relief.

Figure 2-129 Wrapping the AC Adapter Cord Around the Strain Relief

3. Place the charging unit on the posts of the wall screws and push down until it is firmly seated.
2-78
2-76.

Figure 2-128 Inserting Screws for Wall Mounting

ISSUE 1.0
Figure 2-124 Plugging the AC
Installation