Section 1 General Information; Incidence Of Harm - NEC SL1100 Hardware Manual

ISSUE 1.0
Regulatory
GENERAL INFORMATION
This equipment complies with Part 68 of the FCC Rules and the requirements adopted by the ACTA.
On the equipment is a label that contains, among other information, a product identifier in the format:
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The telephone company may make changes in its technical operations and procedures. When such
changes affect the compatibility or use of the SL1100 system, the telephone company is required to
give adequate notice of the changes in order for you to maintain uninterrupted service.
The REN is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as determined by the total RENs, contact the local
telephone company. For products approved after July 23, 2001, the REN for this product is the
product identifier in format: US:AAAEQ##TXXXX. The digits represented by ## are the REN without a
decimal point (e.g., 03 is a REN of 0.3).
Connection to party line service is subject to state tariffs. Contact the state public utilities commission,
public service commission or corporation commission for information.
For single and two-line equipment that connects to the telephone network via a plug and jack, the plug
and jack used with this equipment must comply with FCC Part 68 rules.
A plug and jack used to connect this equipment to the premises wiring and telephone network must
comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant
telephone cord and modular plug is provided with this product. It must be connected to a compatible
modular jack that is also compliant.
TELEPHONE/SERVICE PROVIDER COMPANY NOTIFICATION
Before connecting this telephone system to the telephone network, the following information must be
provided to the telephone company:
1. Your telephone number.
2. FCC registration number:
• When the system is to be installed as a Key Function system (no dial access to Trunk Groups/Route
Advance Blocks), use the following number:
US:NIFKF10BSL1100
• When the system is to be installed as a Multifunction system, use the following number:
US:NIFMF10BSL1100
• When the system is to be installed as a PBX system, use the following number:
US:NIFPF10BSL1100
Ringer Equivalence Number (REN): 1.0B
USOC jacks required: RJ11C, RJEX, RJ2FX, RJ2HX, RJ48C, RJ21X

INCIDENCE OF HARM

If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice is not prac-
tical, the telephone company will notify the customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide
advance notice in order for you to make necessary modifications to maintain interrupted service.
Hardware Manual
SL1100
R-1