Snmp Commands - Avery Dennison MONARCH 9493 System Administrator Manual

SEt IP TRAP n POrt n
Specifies the port that will be scanned for trigger conditions. The parameter is a bit mask.
SEt IP TRAP n TRIGger cccc
Specifies the trigger conditions (cccc) that send a trap (n). The parameter is a
bit mask.
1 On line
2 Off line
4 (not used)
10 Paper out
20 Paper jam
8000 Printer error
SEt IP WIndow nn
Sets the LPD/TCP maximum window size (nn).
S N M P C o m m a n d s
CLear SNMP CONtact <string>
Removes SNMP SysContact.
CLear SNMP LOCation <string>
Removes SNMP SysLocation.
SEt SNMP CONtact
Sets SNMP SysContact.
SEt SNMP LOCation <string>
Sets SNMP SysLocation.
SEt SNMP GETCOMM
Gets SNMP community.
SEt SNMP JETADmin [EN|DIS]
Selects whether to use the JetAdmin protocol.
SEt SNMP SETCOMM1 <string> or SET SNMP SETCOMM2 <string>
Sets SNMP community 1 or community 2 name.
Note: An incoming set request can use either name for comm1 or comm2.
SEt SNMP TRAPCOMM <string>
Sets SNMP trap community name.
<string>
<string>
Telnet Console Commands 6-9