Table of Contents
Advertisement
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-6
Option Installation
5. Disconnect the SCSI cable from the storage system.
6.
Disconnect the power cord(s) from the ProLiant Storage System /U.c
Installation
Perform the following steps to install the Recovery Server option in a ProLiant
Storage System /U.
1. Squeeze the latches and pivot open the two ejector levers securing the
Single Bus I/O board in the rear of the ProLiant Storage System /U. See
Figure 5-3.
2. Pull the I/O board straight out of the storage system.
Figure 5-3. Removing the Single Bus I/O board
!
WARNING: To avoid risk of injury from electrical shock, remove
all power cords to completely disconnect power from the system.
TROJ023.EPS
Compaq ProLiant Storage System /U User Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the ProLiant Storage System U1 and is the answer not in the manual?
Questions and answers