Compaq ProLiant Storage System U1 User Manual page 32

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-4 Installation of ProLiant Storage System /U
a.
b. Push back the tabs in the top of the template (marked
c.
d. Use the reverse side of the template to mark the equivalent
Be certain to begin in the correct place. If there is a rack
component immediately below the position of the storage system,
place the template against the front rails and rest it on the top of the
previously installed component.
them in the correct holes in the mounting rails. The hole pattern
indicated on the sides of the template should match up with the hole
pattern in the rails.
Use a pencil to outline the square holes in the mounting rails
indicated on the template (marked M and C) that will be used to
secure the mounting brackets and the storage system to the
rack cabinet.
mounting holes (marked C) on the rear mounting rails of the
rack cabinet.
WARNING: To avoid injury or equipment damage, the mounting brackets
must be level. If the brackets are not level, the Rack-Mountable ProLiant
Storage System /U cannot be installed correctly.
) and place
Compaq ProLiant Storage System /U User Guide