Configuring The Proliant Storage System /U - Compaq ProLiant Storage System U1 User Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-17 Installation of ProLiant Storage System /U
4. Turn ON the power to the storage system, using the power switch on the
front panel. (The power-on process may take up to 10 seconds to
complete. Wait until the power-on indicator turns green before
proceeding to Step 5.)
5. Turn ON the power to the server(s).

Configuring the ProLiant Storage System /U

The Compaq System Configuration Utility is used to:
Verify the SCSI controller configuration
Verify that the SCSI IDs of the new hard drives are recognized and
configured for your system
The Compaq System Configuration Utility is included on the Compaq
SmartStart and Support Software CD supplied with the new ProLiant Storage
System /U. This utility may be run:
Directly from the boot hard drive of the controlling server
Directly from the SmartStart and Support Software CD
From diskettes created from the SmartStart and Support Software CD
Each of these methods is explained below.
From Hard Drive
Use these instructions to run the Compaq System Configuration Utility if your
server has had this utility previously installed in the Systems partition on the
boot drive.
1. Boot the server normally.
2. Press F10 when the white square cursor is in the upper right-hand corner
of the screen. (Be prepared; this cursor is only present for about 2
seconds during boot.)
3. Select the menu items to configure the hardware.
4. Select Review hardware settings.
Compaq ProLiant Storage System /U User Guide