Compaq ProLiant Storage System U1 User Manual page 48

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-20 Installation of ProLiant Storage System /U
5. The program will prompt you to load four pre-formatted diskettes and
will supply labeling information while the System Configuration Utility
diskettes are created.
6. Be sure all new hard drives are in place and the storage system is
turned ON.
7. Boot the server with the first System Configuration diskette.
8. Select Review hardware settings.
9. Select View or edit details.
10. Locate the SCSI controllers and verify that the installed drives
are displayed.
11. If you are using a Compaq SMART SCSI Array Controller or a
SMART-2 Array Controller Family Product, you should verify the
logical drive configuration, paying special attention to the selected fault
tolerance method. For this configuration information, refer to:
12. Select Save the configuration and exit.
The utility will configure your system to recognize any new controllers and
devices. Reboot your system normally to begin using the added disk space on
the storage system.
the README files for Release Notes for Compaq supplied
operating systems
your software documentation for other operating systems
the documentation supplied with your Compaq array controller
Compaq ProLiant Storage System /U User Guide