Changing Level & Span; Changing The Level; Changing The Span; Changing System Settings - FLIR ThermaCAM P20 Operator's Manual

6.4 Changing level & span
6.4.1

Changing the level

Step
1
2
3
4
NOTE: You can also change the level by pointing to Level/Span on the Image menu, and then change
the level by moving the joystick up/down.
SEE ALSO: For more information about level, see section 9.2.4.3 – Level/Span on page 46.
6.4.2

Changing the span

Step
1
2
3
4
NOTE: You can also change the span by pointing to Level/Span on the Image menu, and then change
the span by moving the joystick left/right.
SEE ALSO: For more information about span, see section 9.2.4.3 – Level/Span on page 46.
6.5

Changing system settings

6.5.1

Changing the language

Step
1
2
3
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004
Action
Press the joystick to display the horizontal menu bar.
If the camera is in continuous adjust mode, point to Manual adjust on the
Image menu and press the joystick.
Change the level by moving the joystick up/down. An arrow pointing upwards
or downwards will be displayed.
Press the joystick to leave level/span mode.
Action
Press the joystick to display the horizontal menu bar.
If the camera is in continuous adjust mode, point to Manual adjust on the
Image menu and press the joystick.
Change the span by moving the joystick left/right. Two arrows pointing away
from each other or towards each other will be displayed.
Press the joystick to leave level/span mode.
Action
Press the joystick to display the horizontal menu bar.
Point to Local settings on the Setup menu and press the joystick.
Move the joystick up/down to select Language.
6.4 – Changing level & span
13