Remove All; Obj Par; Deactivate Local Par; Figure 9.16 Object Parameters Dialog Box - FLIR ThermaCAM P20 Operator's Manual

Camera

Table of Contents

9.2.3.3

Remove all

Point to Remove all and press the joystick to remove all measurement functions

and markers from the screen.

9.2.3.4

10439303;1

You use this command to set the object parameters Emissivity, Distance, T Re-

flected, T Atmosphere, Rel humidity, External optics, Optics transmission, and

Optics temperature. The parameters are selected by moving the joystick up/down

and set by moving the joystick left/right. These parameters settings will be used

by all measurement functions that have not been set locally.

NOTE: Please note the following:

The emissivity file can be stored at root level or at directory level. However, the camera software

■

prioritizes files that are stored at directory level and the directory has to be selected in order to

store the emissivity file in the camera memory. If the camera software does not find an emissivity

file at directory level, it searches for similar files at root level and saves those instead.

If you enter an emissivity value less than 0.30 the emissivity box will begin flashing to remind you

■

that this value is unusually low.

SEE ALSO: For more information about object parameters, see section 16 – Thermographic

measurement techniques on page 80.

9.2.3.5

Point to Deactivate local par. and press the joystick to delete all locally set para-

meters. Locally set parameters are the parameters you set in e.g. the Spot settings

dialog box.

Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004

9.2 – Menu system

Table of Contents

Show Quick Links

Table of Contents