How To Disconnect; Starting Transfer Application; Figure 7.6 Transfer Application - FLIR ThermaCAM P20 Operator's Manual

7.3 – Operation
1
2
7.3.5.2

How to disconnect

3
3
4
7.3.6

Starting Transfer application

The ThermaCAM Connect 3 Transfer application starts as soon as a infrared camera
is connected to the computer. This applies to USB or FireWire, not serial commu-
nication (RS-232). If ThermaCAM Connect 3 Transfer application is closed, you can
easily bring it back up again by right clicking the small camera icon.
SEE ALSO: For more information about the transfer application, see section 7.3.1 – Transferring the
images from the camera to the computer on page 22.
10435503;1

Figure 7.6 Transfer application

Callout
1
Or, you can start the transfer application from Windows Start menu.
28
When a connection is in the process of being established between the camera
and the computer, a notification window pops up.
A few seconds after the connection has been established, a new notification
window pops up.
When the camera is disconnected from the computer, a notification window
pops up.
A few seconds after the camera has been disconnected, the notification window
disappears.
Explanation
Click here to bring up the ThermaCAM Connect 3 Transfer application
4
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004