Installing Thermacam Connect 3; Installing Drivers; Usb Driver Installation Procedure For Microsoft Windows Xp - FLIR ThermaCAM P20 Operator's Manual

7.2.2

Installing ThermaCAM Connect 3

Step
1
2
3
NOTE: If the installation program doesn't start when you insert the installation CD, please start the
program manually by following the steps below.
Step
1
2
3
4
7.2.3

Installing drivers

When the ThermaCAM Connect 3 installation is finished, you have to install the
drivers depending on how you connect the infrared camera to your computer. If
you are using serial communication, you can skip this part and continue with
section 7.3.1 – Transferring the images from the camera to the computer on page
22. Before you continue with the installation, have your Windows installation CDs
available. Make sure that the ThermaCAM Connect 3 installation CD is inserted
into your CD-ROM drive.
If you are using USB or FireWire communication, connect the camera to the
computer and turn on the camera. Windows will now detect the new hardware.
You find the appropriate installations procedure on the following pages, matching
your Windows operating system and communication protocols.
7.2.3.1

USB Driver Installation Procedure for Microsoft Windows XP

Step
1
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004
Action
Make sure the IR camera is switched off and the cable between the IR camera
and the computer is not connected.
Insert the ThermaCAM Connect 3 installation CD into the CD-ROM drive.
Select the preferred language and follow the on screen instructions.
Action
Double-click My Computer on the Desktop.
Right-click on your CD-ROM drive and click Explore.
Double-click SETUP.EXE
Select the preferred language and follow the on screen instructions.
Action
When the system has detected the ThermaCAM, the Welcome to the Found
New Hardware Wizard window appears. The wizard asks: What do you want
the wizard to do?
Select Install from a list or specific location.
7.2 – Installation
19